Terra

Approach 1: Use a round tube clamp to attach to the vertical round tube the footrest pivots around; offset it with an Adapter Plate and an L-AE to avoid the footrest, lights and armrests.
Approach 2: Drill two holes into the side frame, in front of the light. Next, attach an Adapter Plate. Use an L-Angle Extension and/or Angle Adjustment plate if necessary. Then, attach a Solid Wheelchair Bracket.

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

  • Get around obstacles such as trays, brakes, footrests and armrests
  • Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
  • Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

How to mount: 

Use a Round clamp on the back side of the upright tube the footrest swings on. Either attach the Solid Wheelchair Bracket to the Round Clamp, or use an L-Angle Extension plate to offset the Wheelchair Bracket and post.

Recommended mounting hardware: 

Round clamp (WC-R-) (WC-R-1, WC-R-78)
Solid Wheelchair Bracket (WB2)

Installation support: 

Round Tubes - Upright Vertical

How to mount: 

Custom: Drill holes through the square frame and use bolts and lock nuts to secure an Adapter Plate 4. Tip: If you orient the AP4 vertically and then attach higher on the AP4, the Wheelchair bracket will be above the footrest so it can still be swung to the side; and it will not obscure the light. Offset it with an L-Angle Extension Plate and/or Angle Adjustment Plate as needed.

Recommended mounting hardware: 

Adapter Plate 4 (WC-AP4)
L-Angled Extension Plate (WC-LAE)
Solid Wheelchair Bracket (WB2)

Installation support: 

Custom fabrication
Suggested extra parts

Other hardware: 

Bolts and lock nuts to attach the Adapter Plate 4, through the holes. Use M6 or 1/4" bolts.