Bantam

1" bridge clamps assembled to the AP4 plate

AP4 attached to tubing under tray with Angle Adjust plate

L-Angle plate attached to AAP parallel to edge of tray

Offset options

Offsets attach to the wheelchair attachment hardware, and are used to:

Get around obstacles such as trays, brakes, footrests and armrests
Position the Wheelchair Bracket so the post is in the optimal position (post can be inserted and removed, brakes are unobstructed, footrests removed, accommodate the tray, etc)
Adjust the angle of the hardware and/or bracket to make sure the post is vertical

These plates can all be used to offset. To figure out which offset plate will work for you, see our Offset Guide.

L-Angled Extension Plate (WC-LAE)

Adapter Plate 2 (WC-AP2)

Adapter Plate 4 (WC-AP4)

Angle Adjustment Plate (WC-AAP)

How to mount:

Attach the WC-AP4 plate to the round tubing under the tray with the 1 inch bridge clamps ******(be sure threaded holes on the AP4 are towards the outside edge of tray)*****. Attach an WC-AAP to the WC-AP4 plate. Find the correct series of holes on the AAP plate to attach the L-Angle plate (LAE) so that it is parallel to the edge of the tray. Attach the post clamp (WB2) to the LAE.

Watch our step-by-step guide where owner, Peter Loeffler, walks you through how to attach to your Quickie 2. If there is a problem with the embedded video, here is the link to the YouTube Playlist:

https://youtube.com/playlist?list=PLicITkmTakB78X5usJmGyBv0xi_ADRtFS&si=NbASMckoTArW_GSl